|
Problem J1772 Cable Defective Repair Process Open case with wide chisel and small sledge hammer (2lb), Confirm EV Charger works (using EV Doctor Go NoGo Tester), Found the ‘Clip in Connector is damaged’. Remove display & PCB, remove ‘Clip in Connector’. Solder in preowned J1772 cable. NOTE putting the PCB back in is very tight because J1772 cable is in the way, Install nut last Seal case with epoxy, Re test
6 Comments
8/3/2022 12:47:36 am
Really informative article, I had the opportunity to learn a lot, thank you. https://www.takipcikenti.com/instagram/turk-takipci/ 8/11/2022 03:24:04 pm
Really informative article, I had the opportunity to learn a lot, thank you. https://bit.ly/instagram-takipci-satin-al-takipci 8/19/2022 02:02:21 pm
Really informative article, I had the opportunity to learn a lot, thank you. https://guvenbozum.com/ 9/9/2022 11:39:06 pm
https://taraftarium24izle.net/category/futbol/ 9/14/2022 03:07:04 pm
Really informative article, I had the opportunity to learn a lot, thank you. https://bit.ly/site-kurma 9/24/2022 12:14:41 pm
sikayetgir.com En trend şikayetvar yorumlarını sizin için yayınlıyor. Leave a Reply. |
AuthorDavid R Ahlgren, aka EVDOCTOR 4EARTH, #1 Expert on the Web Archives
April 2022
Categories |
RSS Feed
